![]() ![]() ![]() Also, the downloaded profile will stay in the Cougar, even after a reboot. After the download of the profile into the Cougar, you can close and the CCP and Foxy, no need to keep that running in the background when you run DCS. If you have made them, you can select them from within the CCP. After the installation of the Foxy software you will also have a direct link (desktop icon) to the CCP so you don't need to open Foxy to download different profiles made for different aircraft. You use it to write profiles which can then be downloaded into the Cougar through the CCP (Cougar Control Panel which is acessable from within Foxy). those are the ones that I state on the documentation.įoxy is not a GUI (Graphical User Interface) like the TARGET GUI is. I do try to use the standard module's bindings, but sometimes there are command for which the developer has not provided any key-binding. Throttle Cutoff Release - Depress = LCTL + a Device is now working properly with no other changes other than using a USB 2.0 port.Please define the following keyboard bindings on DCS -> Options -> Controls for the F-16CĬRS Set / Brightness Control Knob - CCW/Decrease = LCTL + kĬRS Set / Brightness Control Knob - CW/Increase = LSHF + kĬountermeasures_Management_Switch-Aft = LCTL + mĬountermeasures_Management_Switch-Fwd = LALT + mĬountermeasures_Management_Switch-Left = LSHF + mĬountermeasures_Management_Switch-Right = RCTL + mĬAMERA/GUN_Trigger-FIRST_DETENT = LCTL + l This is the service that is being launched - Įdit 3: Found a thread where someone said their wheel only worked in USB 2.0 ports.and that worked for me. I attempted to have it launch in Administrator + compatibility mode, but that did nothing. It immediately launches when the wheel is plugged in. But when I attempt to update the firmware, it can't.Įdit 2: This is the process that once killed will allow the control panel to open. The firmware updater also can see the wheel now, and also shows version 0. Even more bizzarely, my firmware is showing 0. The control panel shows the wheel turning and its position, brake and gas being pushed as well as all the buttons.but when I go to test forces and click on any of them, they do nothing. I got the control panel to open - there was a thrustmaster process that seemed to be hogging up the wheel, killing it then allowed the control panel to open. I updated the firmware (I received it on firmware 31, and the most recent is 34) and hoped that would fix it, but seems to have done nothing.Įdit: Issue just keeps getting weirder. I plugged it in to my laptop with Windows 10 and was immediately able to get the Thrustmaster Control Panel working.genuinely the first time in months on Windows 11 that I've had an issue like this. I've spent several hours researching and poking around to no avail, so I'm a bit stuck. The wheel inputs do work, just with no force feedback (when I go into ACC, I can apply throttle/brake and steer).Īny suggestions would be massively appreciated. I tried running it in Windows 8 compatibility to no avail (I'm running Windows 11, which others have said is supported). I'll click on the "Control Panel" icon, and it'll open the "Game Controllers" Windows panel, I'll click on "Properties", but then the window freezes, and the Thrustmaster Control Panel never loads. I want to use it with my PC for now to play ACC, but I can't get the Thrustmaster Control Panel to load. Hi all, as the title says, I bought a T300 RS (non GT, so no clutch) and my PS5 is currently out of commission. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |